DLM – Additional configuration for RS-485 communication
- Landis+Gyr – EV Editor 1
In addition to the Meter’s Modbus address parameter found on the previous screen, the remaining communication parameters on this screen must also be correctly configured to ensure proper communication between the meter and the station.
Baud rate
Databits
Pairity
Stop bit
The first time you open the additional RS-485 configuration parameters screen, the listed parameters may already be preconfigured. However, the actual values of these parameters may differ from the preconfigured values. It's important to verify and set the correct actual values accordingly. For the correct actual values, refer to the meter documentation.
To edit values of the settings, tap the icon.
An edit icon is displayed next to the value only if you have permission to modify it; otherwise, the value is read-only.
Warning! Before installing, wiring, handling or accessing the charging station in any way, make sure to read, understand and follow the Safety Guidelines.
Any graphic material provided in this documentation library is subject to variation and may not reflect the most recent updates or changes due to ongoing development and the implementation of new features.
Owing to periodic improvements of our products, the supplied products can differ in some details from the information stated in this documentation library. The information is subject to alteration without notice.
The English version of this documentation is the official and authoritative source of information. We make every effort to ensure that translations are accurate and clear; however, we do not accept responsibility for any errors, omissions, or misinterpretations in translated versions. In case of discrepancies, the English version will take precedence.