How to configure power meters on INCH DUO.
- Landis+Gyr – EV Editor 4
- Žiga Dežman
When changing the MID meter or the whole power circuit you will need to configure the new MID meter. To do that you will need firstly physically disconnect the green cable of the working MID meter from the power board and then configure the new MID meter in web interface of the charger.
There are two green MID meter cables connected on the power board.
Disconnect the green MID meter cable for the socket that works/hasn’t been replaced and leave the new MID meter cable connected. Example if you have faulty MID meter on socket 2 you will need to disconnect the green MID meter cable for the socket 1 and leave the green MID meter for socket 2 connected.
After disconnecting the MID meter from the power board you will need to log into web interface and go under EVSE configuration. There you will see option ¨Change MID meter¨. After configuring the new MID meter, you can reconnect the other MID meter and test the charger
Note*: Make sure you choose the right socket in the web interface.
Â
Warning! Before installing, wiring, handling or accessing the charging station in any way, make sure to read, understand and follow the Safety Guidelines.
Any graphic material provided in this documentation library is subject to variation and may not reflect the most recent updates or changes due to ongoing development and the implementation of new features.
Owing to periodic improvements of our products, the supplied products can differ in some details from the information stated in this documentation library. The information is subject to alteration without notice.
The English version of this documentation is the official and authoritative source of information. We make every effort to ensure that translations are accurate and clear; however, we do not accept responsibility for any errors, omissions, or misinterpretations in translated versions. In case of discrepancies, the English version will take precedence.