Design preparation folder

Basic description

This document outlines the most common branding and customisation possibilities on Etrel INCH Duo charging equipment. Below, you will find branding guidelines regarding environmental, usability and production aspects, that will help you find the best solution for your graphic communication endeavours.

The recommendations are sourced from our practices on the field, which proved to stand the test of time and environment as well as from our own environmental and usage simulations in the lab.

We would like to remind you that regardless of the quality of design, the quality of selected materials/applications, service provider selection and lead time requirements could highly influence the outcome and longevity of the branding project in the field.

Please note that following the branding practices described below might yield a different result in different environments. Different charger locations, weather conditions, temperature, material and application methods all influence the suitability of a particular branding method. Therefore, we recommend you consult your preferred supplier on the branding solution for your project.

Door & Housing Colours

INCH Duo door & housing colour options:

For larger orders or special projects, Etrel offers custom colour solutions. Please note that minimum order quantities apply for this product customisation. Contact your sales representative for a commercial offer.

Branding Possibilities

On-screen branding

Branding on the screen can be done through:

• Wake-up logo,

• Start-of-charging advertisement.

Both branding options can be set through the MyINCH web app under the Customisation section. A template is available in the ETREL Branding pack.

Sticker branding

NCH Duo offers a large flat surface for custom branding with stickers. When you plan such branding, we recommend opting for a non-structural surface finish as it tends to work best.

Some considerations when planning your branding project, based on the feedback we collected from the field and lab testing:

Outlines and templates for visualisations are part of ETREL Branding pack.

When designing sticker branding, please consider the guidelines below.

USE STANDARD COLOURS

We highly recommend using a standardized colour palette like CMYK, which is widely recognized and utilized in the industry.

OPT FOR SMOOTH SURFACE FINISH

To ensure the best possible applications of stickers we recommend ordering smooth instead of powder-coated surface finish.

COMPLY WITH THE STICKER AREA MARGIN​

When designing sticker branding, we recommend you consider sufficient margin from the edges. Applying stickers too close to the edge or bend could lead to weaker application and could result in peeling. For safe application apply stickers on surfaces within the marked safe areas in grey (26 mm margin from the edges).

AVOID CUTOUTS AROUND CHARGER EXTERNAL ELEMENTS

Cut-outs around chargers’ external elements such as sockets, antennas or UI could present a major hurdle for sticker application due to tolerances and sticker stretching. Though well-designed, the results could be unsatisfactory, and the production costs could increase significantly.

MANAGE NARROW LINES

When designing long narrow lines, we recommend considering larger margins so potential small uneven deviations from the edge along the line would not be visible.

AVOID USING THE SAME COLOURS IN DIFFERENT APPLICATIONS

To ensure proper visual colour matching, avoid placing stickers close to the dyed housing elements. Although stickers are expected to be of the same colour as the housing, they might appear slightly different, due to the difference in surface materials. Weather conditions and UV degradation could eventually cause visual discrepancies as well.

AVOID SHARP EDGES AND THIN LINES

Sharp edges and corners have a smaller glue surface and are more likely affected by external factors. Wherever possible avoid sharp edges, acute angles, small cut-outs or isolated slim lines in order to preserve stickers intact regardless of the environment. When you cannot avoid small and delicate shapes (e.g. logotypes), consider printing them on a larger sticker surface.