Replacing the Payter module - PEM-0962
Tools required
7mm spanner
Large Phillips screwdriver
Small Phillips screwdriver
Parts needed
Payter terminal PEM-0962
SIM card (from the previous Payter module)
SAM card (from the previous Payter module)
Disconnect the LTE antenna and the power supply.
Unscrew the four wing using the 7mm spanner.
Remove the Payter module from the casing and remove the protecting rubber.
Remove the three screws and open the two covers to access the SIM and SAM cards.
Remove the SIM and SAM (CCA module and HSH module) cards, place them into the new Payter module and lock the in place, by pushing the mechanism towards the narrower part of the cards.
Return the protective covers back in place and screw in the three screws, as seen in the picture above.
Return the protective rubber.
Return the Payter into the casing and screw back the nuts.
Filter by label
There are no items with the selected labels at this time.