Page Comparison

...

1. to enter router Web interface type http://192.168.1.1 in your web browser. Welcome page:
   

   Image RemovedImage AddedImage Added

2. use default username: admin and password: admin01 when prompted for authentication. You will be asked to change password before you can continue. (If password was already changed, check label on Teltonika)

3. In right upper corner select Advanced mode to see all options. This will allow you to choose from a larger variety of settings.
   

   Image Added

4. Click System - Administration and choose Access Control to check which options are enabled:
   

   Image Added

5. click Services - Auto reboot - use IP address that you can ping from this SIM card and APN (OCEAN IP, radius server IP, ... )
   

   Image Added

6. click Network - Firewall and then Port forwarding. If you have more charging station connected to the same router you will have to make more forward rules to each station. In that case you will also have to change IP of the charging station. Example: INCH 1 external port 10000, internal 80, local IP 192.168.1.250
   

   Image Added

7. click Network - Interfaces - edit LAN. You can change router IP here if needed. Go to Advanced settings after that
   

   Image AddedImage Added

8. click -Network - Wireless and disable / change this option if not needed

9. click Network - Interfaces - edit Mobile and configure APN settingsclick Status - Overview
   

   Image Added

   
   

   Image Added

10. Click Network - Interfaces. If your APN settings are correct you will see IP and mobile state:APN name
    

    Image Added

11. If you want to change password or router name click System - AdministrationSystem users - change password
    

    Image Added

12. One of the ports on router is configured as WAN. If you need it as LAN, follow those steps:

• navigate to Network > Interfaces
  

  Image Added

• Disable WAN and WAN6 interfaces and then Click Save & Apply
  

  Image Added

• Next we will edit our LAN interface and navigate to Physical settings where we will add Interface item from the dropdown menu.
  

  Image Added

• In interface tab, add "eth1" interface
  

  Image Added

• It should result in something like this.
  

  Image Added

• Once you're done with configurations above just save any changes you made.

• Wait a minute or two for the changes to take effect. If there is no effect, reboot the device.

...

At this point, WAN port should work as LAN. Go ahead and try to swap from your to current port to WAN, you should be able to ping the router.